23
Slideout Operation (For Models 28R, 26S, 30T)
Extending Room
1. Release the travel lock behind the center door of the overhead cabinets located
above the sofa.
2. Release second travel lock located below the sofa.
3. For one person operation, push slideout into the extended position by pushing on
the sofa. For two person operation, push each side of the slideout unit until the
slideout locks in place. Loud clicking of the slideout at this point is normal.
Retracting Room
1. Lift sofa skirt.
2. Pull up on release handles and pull slideout to the retracted position.
3. Lock the bottom travel lock.
4. Lock the top travel lock.
Getting Connected
Upon completing the setup of your travel trailer, you are now ready to make attachments
to various facilities as listed but not limited to:
1. Fresh water hose supply.
2. Waste water hose connection(s).
3. 120-volt power cord electrical hookup.
4. Turn on LP propane tanks and light pilot lights for any appliances. Remember there
may be air in your LP propane lines. Be sure to bleed them before planned usage.
5. Open any windows and roof vents as desired for ventilation.
You may have additional accessories and options, such as an awning on door side, which
need to be opened. Separate instructions are provided by the manufacturer of the
component.
CAUTION:
When preparing to depart or move, reverse the procedure above.
Remember, open roof vents, windows, TV antennas left in up position are subject to
wind damage in transit.
See the process to follow before departing from your campsite under the hitching
procedures listed earlier in this chapter.
