25
Maintenance
See “TV Antenna Maintenance” in Chapter 7.
Closing the Beds (Kiwi Models Only)
1. Remove thin cushion from under extension and fold bed cushion at crease. Remove
bow brace from the bracket on the roof and pull toward you, removing it from bed
bow peg on the bed bow.
2. From outside of the unit unsnap the tent from the bed board and push the tent into
the unit.
Important:
Make sure the bed tent is pushed in at least 1" above the side
bulb seal. (Figure 3-8)
3. Place bed bow under the bed cushion and line up the cushion strap with the Velcro
strips on the sides of the bed board. Secure the straps to the Velcro strips.
4. Remove or loosen the bed board securing knobs or latches and push the bed board
into place.
CAUTION: If the bed does not close easily, inspect the bed cushion from the sides
looking for obstructions. Once obstruction is located, lower the bed board, correct
the obstruction and try again.
5. Secure the bed board into place with the securing knobs or fasteners.
(Fig. 3-8)
FIRE EXTINGUISHER
A fire extinguisher is installed in each vehicle and is located near the entrance door in
the RV travel trailer. Be familiar with its location and operating instructions as printed on
the extinguisher. It’s too late to become familiar with an extinguisher when an emergency
is at hand.
The fire extinguisher is a dry chemical, non-refillable extinguisher. Do not test this
extinguisher. Doing so will cause loss of pressure making the extinguisher unusable. The
extinguisher must be discarded and replaced by a new one if any use has occurred.
J-Mold
Bulb Seal
