75
Section 8: Plumbing System
Draining The Fresh Water System
Water tanks may be drained through a valve located near the tank. A recreational vehicle
with a demand pressure pump system will have low-point drains attached to the water lines
(normally located near the water tank).
These low-point drains will release water in the supply lines by opening the valves and all
faucets. The water heater has its own drain plug. To drain the permanent fresh water holding
tank and supply lines:
1.
Turn the water heater power OFF (turn off the electric and LP gas
switches).
2.
Open all faucets, including the outside shower faucet (if so equipped).
3.
Open the “fresh tank drain” valve. Methods to drain the fresh water
tank may vary by model. Fresh water tanks can be drained by one of
the following methods:
A white plastic drain attached to the exterior wall
A valve located inside the RV adjacent to the water tank (turn 45° to open or
close).
Pull the white “T” handle on the fresh water holding tank to drain the water
Exterior Fresh
Water Drain
Filters should be replaced at the beginning of each camping season or if they have come
into contact with contaminated water
. When not in use, the water filter cartridge should
be stored out of freezing temperatures. RV antifreeze will damage the water filter cartridge.
Filter locations will vary by model. They are typically located in a compartment behind the
utility center (if so equipped).
To Replace Canister Filter Cartridge
1.
Turn off water supply using two valves located on the water lines on each
side of the canister. Water pump should be OFF.
2.
Place drip pan below filter housing to catch any spillage.
3.
Press the red button on top of the filter housing to release pressure.
4.
Using a spanner wrench, rotate the filter housing. Unscrew the housing
completely, dump water out and remove the filter (dispose of the old filter
properly).
5.
Clean the inside of the filter housing with mild detergent. Thoroughly rinse
and wipe clean.
6.
Remove the O-ring from the groove in the housing and wipe clean. Coat with petro-
leum jelly.
7.
Replace the O-ring in the groove, making sure it is properly seated.
8.
Install the new filter cartridge.
9.
Replace the canister housing (hand tighten is normally sufficient).
10. Turn on the water supply, turn the pump ON, open a faucet and check for leaks. Turn
the pump OFF afterwards.
NOTE: There is
no bypass
feature on a canister style water filter. The water
filter
must
be removed before sanitizing or winterizing the RV.
Each new recreational vehicle is winterized with RV antifreeze before it is shipped to the
dealer. To use the water purification system, full system canister water lines need to be
flushed of antifreeze and then the filter installed in the canister before use.
Refer to the manufacturer’s owner’s manual and the label on the water filter cartridge for
further information.
Table of Contents
Summary of Contents for SENECA PRESTIGE 2023
