Section 8: Plumbing System
52
Water should now be available to all fixtures in the RV.
To disconnect from city water, turn off water at the pressurized source first. Disconnect the
hose from the water source, (to release pressure off the system) then disconnect the hose at
the city water connection on utility center last.
Filling the Fresh Water Tank (Pressurized fresh water source)
1.
Connect the fresh water hose to the CITY WATER inlet on the utility center.
2.
Set the color-coded valves to the POWER FILL TANK position (refer to the Utility
Center label for valve configuration).
3.
Connect the other end of the hose to a pressurized fresh water source (faucet or spigot).
4.
Turn the pressurized water source ON, the tank should begin filling.
5.
When water has reached the desired level, turn the pressurized water source OFF.
DO
NOT OVERFILL
(tank level can be viewed on the monitor panel on the touch screen).
6.
Disconnect water source from the spigot/faucet first, then disconnect from the city wa
-
ter fill inlet on the utility center.
Dry Camping (pump supplies water from the fresh water tank)
1.
Make sure the fresh water tank has an adequate supply of water.
2.
Set the color-coded valves to the DRY CAMPING setting position (refer to the Utility
Center label for valve configuration).
3.
Turn the pump switch ON. The LED indicator light below the pump switch will be lit
if the pump has power.
4.
Water should be available to all fixtures. Pump runs when a fixture is opened.
5.
Turn pump OFF when water is not being used.
NOTE: To fill the fresh water tank without a pressurized water source, refer
to SANITIZE (Siphon Fill) section, and use a container holding fresh po-
table water and your fresh water hose. Water will be drawn into the tank by
the pump. There is no gravity fill inlet on the recreation vehicle.
Handheld Shower
A handheld shower assembly with both hot and cold water is included for use outside of your
recreational vehicle.
Be sure the water heater is ON and had sufficient time to heat the water.
If dry camping, be sure the 12-volt water pump is ON.
Remove the handheld shower from its holder.
Turn ON the hot and cold faucet knobs, and adjust the water temperature as de-
sired.
To activate the handheld shower turn ON the sprayer head attachment (some mod-
els).
To turn off the water,
always
close the hot/cold control (faucet) knobs. The lever on the
showerhead will not completely stop the flow of water; this is intentional to allow for drain
-
ing. After the water has been allowed to drain from the showerhead, return it to the outside
shower storage. Any remaining water in the shower hose will drip or run out; this is not a
leak but performs as intended. If you are dry camping, turn the water pump OFF.
Turning off the water with the showerhead lever can also create a condition where the hot
and cold water will mix through the outside shower faucet, thereby reducing the temperature
of the hot water. It can appear as though the hot water heater is not working properly.
NOTE: The showerhead may be removed from the hose so that it will drain
faster. If you remove the showerhead, be sure to reassemble it prior to stor-
age.
Table of Contents
Summary of Contents for SWIFT Ali 2023
