102
Section 8: Plumbing System
Fresh Water Connections
Your recreation vehicle may be equipped with one or both of the following fresh water con-
nections: city water and gravity fill. The city water fill has a threaded connector with a city
water connection label next to it.
Do not remove this label.
Using City Water Fill (if so equipped)
Remove the connection cap and attach a non-toxic
drinking water hose to the threaded inlet.
1. The other end of this hose should be connected to
a pressurized fresh water source (such as a faucet
or spigot). You should use a non-toxic drinking
water hose dedicated only to supplying fresh water
to the vehicle.
2. Turn ON the water at the water source. Open the cold water supply faucets to bleed air
from the water lines. When the water lines are nearly full, you may experience some
“air pockets.” Allow these to escape before closing the cold water supply faucets.
NOTE:
The City Water Fill inlet when connected to a pressurized fresh
water source sends water through the water lines and fixtures without the
use of the pump. The fresh water tank cannot be filled using the city water
fill (the gravity fill is used to fill the fresh water tank).
hicle is not hooked up to city water. Once activated,
the water pump (also known as the demand pump)
will self-prime, and provide water. The pump is de-
signed for
intermittent use only.
Using the pump
continuously or with high pressure will shorten the
life of the pump and is not covered in your warranty.
Periodically check the in-line water pump strainer
for accumulated debris. To clean, shut off the water
pump, unscrew the clear cap, remove the re-useable
metal strainer, clear any debris, then reinstall.
For additional information on the care and operation of the pump, read the safety and operat-
ing information in the pump manufacturer’s owner’s manual.
Water Pump Switch (if so equipped)
Most water pump switches illuminate when the water pump is activated. Typical switch
locations are in the back of the unit or on the monitor panel. When the water pump switch
is ON the pump runs until 45 lbs. of pressure has been achieved. The red light will stay
on. The water pump automatically recycles when pressure drops. Some cycling may occur
depending on the volume of water being released. Turn the water pump switch OFF when
it is not in use.
The water pump switch should be in the OFF position when the RV is left unattended
for any amount of time. If something would happen to the water system, this may help
limit water damage to a smaller area.
Table of Contents
Maintenance Record
Summary of Contents for WHITE HAWK TOWABLES 2022
