73
Section 6: Electrical System
Command Control System (if so equipped)
The Command Control System encompasses several types of Bluetooth controlled systems
in your Recreation Vehicle.
The Command Control System is capable of controlling some or all of the following features
depending on the Bluetooth system and your model:
RV Auto Leveling System
Power Jacks and Stabilizers
Interior and Exterior Lighting
RV Slideout Rooms
Power Awnings
Generator
TV and Bed Lifts
HVAC Thermostat
Gas and Electric Water Heaters
Water Tank Levels (black,gray,fresh)
Battery Levels
Back Up Camera Systems
Water Pump
Kitchen and Bath Vents and Covers
Door Locks
TV, Radio and DVD Systems
Automatic Fireplace Control
Automatic Ramp Door (Toy Hauler)
Propane Sensor
Temperature Sensor
For detailed user information, refer to the manufacturer’s user guide.
Test all GFCI receptacles monthly
Push in the GFCI “TEST” button. The GFCI “RESET” button should pop out
indicating the GFCI receptacle has been “tripped” and interrupted 120-volt power.
Push in the GFCI “RESET” button to restore 120-volt power.
Contact your independent dealer for assistance if the GFCI “RESET” button does not restore
120-volt power and pops back out.
A “tripped” GFCI breaker indicates that abnormally high 120-volt current flow (a ground
fault) was detected. All ground faults must be repaired before use of the recreation vehicle.
NOTE:
On some systems, the switches turned on with a Control App or
the touchscreen override switches at the command center panel. If a de
-
vice is turned on with the app or the touchscreen and then the touchscreen
or the app were to fail, that device would not be able to be turned off using
the command center panel switches. To regain command center panel
control, battery power would need to be disconnected from the RV to reset
the system. This can be done by turning off the Battery Disconnect switch,
or removing the power cable from your battery, then turn the Battery
Disconnect switch back on or re-attach the battery cable.
BMPro Mini System (if so equipped)
The Jay Command BMPro Mini is a small control panel used to monitor and control various
systems in your RV.
The system has 3 parts: the NODE, the DISPLAY and the JayCommand Smartphone App.
The mini control panel and the Smartphone App connect to the NODE via Bluetooth. The
JayCommand App is available for download for IPhone or Android devices through Google
Play store or the App Store. (Search “JayCommand”).
Table of Contents
Maintenance Record
Summary of Contents for WHITE HAWK TOWABLES 2022
