WARNING
*BECAUSE OF THE SIZE AND WEIGHT OF THE SYSTEM, A MINIMUM OF
THREE ADULTS ARE REQUIRED FOR THE FOLLOWING STEPS*
CsrEriJ
A. Slide c.1 18mm Thick I/Vasher (U3) over each of the ,)--Bolts (U2) as shown in F!GUHE. -1 A.
8. Remove the Padding from Main Post (A). Place the Main Post (A) over the J-Bolts. Slide a i8m111
Thick Washer (U3), a Lock washer 18mm (U6) and thread a 18mm Hex Nut (U4) to each J-bolt.
Tighten the Nuts only a few turns onto the J-Bolts as shown in FIGURE 18.
C. !f the Main Post (A) is not excictiy vertical, ..:.1cljust the 18mm �l--Bolt Hex Nuts (U4) located under the)
Post base. Tlqhten all of the Hex Nuts (U4} Above Post base when Main Post (A) is vertical.
NOTE: Face the Main Post (A} with Actuator Bracket facing awciy f
r
om playing court (as sho
1
Nn in FIGURE 1C).
U3
U2
I ( - - - - - - - ,
l STEP2 J
FIGURE 1A
FIGURE 1B
Nylon washer #1 :ray
be factory installed
A. Slide the Main Extension Arm(F) over the top of the Main Post (A)
and attach to the lower pivot tube with a M18x320mm Hex Bolt (#5),
two M18 Flat Washers(l/11 ), two Nylon Washers M18 (#1) and one
Lock nut M18 (#14).
Do not over tighten this bolt and nut.
Playing Court
FIGURE IC
Note: make sure Nylon washers locate between Main Extension Arm (F) ancf Post (A).
The Nylon washers ,nay be factory assembled.
B. Connect Actuator(B) to the mounting bracket welded
in the
middle
of Post (A), usino one Hex Bolt
M16x135mm (/19), two flat Washers for M16 Bolt (#12),
two Nylon Washers (#2), ,me! one Lock Nut for i1J116 bolt
(//'15).
Nole: make sure Nylon washers
uo
he/ween Actuator and
lvlountinq E3mcl<et.
C. Attached Crank handle to the actuator. Slide F<.einovable
Cn,ink handle onto the sl·1aH sticking out of Gear Box
(Actuator), lock it in picicc with attached pin.
6
•
I
15
Back
