MOUNTING THE GOAL
1) CHECK CONTENTS OF BOX FOR GOAL,
NET AND HARDWARE PACK
2) REMOVING THE COVER PLATE BY
REMOVING THE PHILIPS HEAD SCREWS
ON BOTH SIDES,
3) SELECT THE PROPER MOUNTING
HARDWARE FROM THE HARDWARE
PACK, THIS WILL VARY BASED ON
BACKBOARD AND HEIGHT ADJUSTER
4) INSTALL THE FLANGE LOCKS NUTS
FROM THE BACKSIDE OF THE
BACKBOARD,
5) INSPECT AND TIGHTEN ALL
HARDWARE BEFORE REATTACHING THE
GOAL PLATE,
WARNING
• DO NOT REMOVE, LOOSEN OR TAMPER
WITH ANY SCREWS OR BOLTS.ASSEMBLY IS
UNDER PRESSURE AND ANY DISASSEMBLY
MAY CAUSE INJURY AND VOID ALL
WARRANTIES.
• IN ORDER TO MAINTAIN WARRANTY, GOAL
SHOULD BE INSPECTED, GREASED AND
LUBRICATED BEFORE EACH SEASON.
• ONLY ADJUST BREAKAWAY STRENGTH
AFTER GOAL HAS BEEN MOUNTED.
NOTE
•THE TWO VERTICAL SPRINGS CAN BE
TIGHTENED IF MINOR LOOSENESS OR
RATTLING OCCURS. ONE OR TWO TURNS OF
THE HEX NUT IS SUFFICIENT. DO NOT OVER
TIGHTEN AS IT WILL DAMAGE GOAL
MECHANISM, BACKBOARD AND COULD LEAD
TO PLAYER INJURY.
ADJUSTING BREAKAWAY
•AMOUNT OF FORCE REQUIRED TO RELEASE
LOCKING MECHANISM CAN BE ADJUSTED ON
BREAKAWAY GOALS.
REMOVE THE COVER PLATE AND INSERT 3/16"
ROUND TOOL IN THE HOLE IN THE ADJUSTMENT
SCREW MECHANISM. PLACE FLAT WRENCH
PROVIDED WITH GOAL OVER HEX HEAD PORTION
OF ADJUSTING SCREW (SEE FIGURE A). MOVING
THE WRENCH AND ROUND TOOL ALWAYS FROM
EACH OTHER WILL INCREASE BREAKAWAY
FORCE REQUIRED, WHILE MOVING THEM
TOWARD EACH OTHER WILL DECREASE
BREAKAWAY FORCE.
DECREASE
ADJUSTMENT PIN
-c,,scoN
INCF?EASE
l,iJ
f),
'TENSION
GBR360
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
@COPYR!GHT 2016 JAYPRO SPORTS, Ll.C AU. RIGHTS RESERVED
Sheet 1 of 1
