DATE:
DRAWN BY:
5/23/2018
MODEL NUMBER:
CHECKED BY:
PRODUCT NAME:
BSA
TC-710 WIRING DIAGRAM
WVB
REV:
SHEET:
2 OF 2
x.x = + 0.1
x.xx = + 0.01
x.xxx = + 0.005
X
X
= + 1/16"
X = + 1/16"
TOLERANCES:
PROJECTION METHOD:
THIS DRAWING IS THE SOLE PROPERTY OF JAYPRO
SPORTS INC. AND MAY NOT BE REPRODUCED
WITHOUT WRITTEN PERMISSION OR CONSENT
UNLESS OTHERWISE SPECIFIED
NOTES:
1.
ALL WIRING SUPPLIED BY ELECTRICAL CONTRACTOR. WIRING TO BE IN ACCORDANCE WITH ALL NATIONAL
AND LOCAL ELECTRICAL CODES.
2.
*IMPORTANT* MOTORS NEED TO ROTATE IN REVERSE DIRECTION FROM EACH OTHER.
3.
SET THE LIMIT SWITCHES ON MOTOR #1 ONLY. MOTOR #2 LIMIT SWITCHES ARE NOT USED MUST BE LEFT
IN THE DEACTIVATED POSITION (SWITCHES DEPRESSED). WITH CAUTION, USE TRIAL AND ERROR TO
DETERMINE WHICH LIMIT IS UP AND DOWN. REFER TO THE TC-710 INSTALLATION MANUAL FOR ADDITIONAL
INFORMATION REGARDING SETTING THE LIMITS.
4.
SYNCHRONIZED MOTOR CONTROLLER FITS WITHIN STANDARD FOUR (4) GANG MASONARY ELECTRICAL
BOX, SUPPLIED BY OTHERS.
5.
KEY SWITCH FITS WITHIN A 3" X 2-1/4" X 2-1/2" (H X W X D) ELECTRICAL BOX, SUPPLIED BY OTHERS.
6.
CONTACT JAYPRO SPORTS AT 800-243-0533 WITH ANY QUESTIONS PRIOR TO WIRING. INCORRECT WIRING
COULD DAMAGE THE SYNCHRONIZER, MOTOR(S), OR CURTAIN SYSTEM.
TC-710 WITH DUAL MOTORS,
SYNCHRONIZED MOTOR CONTROLLER,
KEY SWITCH OPERATED
!!! WARNING !!!
WIRING FOR MOTOR #2 IS REVERSED FROM MOTOR #1.
FOR PROPER OPERATION, MOTORS ARE REQUIRED TO
ROTATE IN OPPOSITE DIRECTION.
ELECTRICAL SPECIFICATIONS:
INPUT: 120 VAC +/- 10% 50/60 HZ
OUTPUT: 120 VAC 10A (5A PER MOTOR)
SIZE WIRE ACCORDING TO RUN LENGTH AND LOCAL CODE
DOWN
MOTOR
#1
KEY SWITCH
(KS-13)
UP
GROUND
OPTIONAL
JACK
SYNCHRONIZED
MOTOR CONTROLLER
(HM6156)
MOTOR
#2
RED
BROWN
BROWN
RED
GREEN
WHITE
BLACK
FROM 120V
POWER SUPPLY
GREEN
WHITE
BLACK
RED
GREEN
WHITE
BROWN
RED
GREEN
WHITE
RED
BLACK
RED
BROWN
WHITE
GREEN
L
O
W
V
O
LT
A
G
E
UNUSED
UNUSED
UNUSED
TC-710, DUAL MOTORS
