Rev: -
[Type text]
Page
2
of
15
1. 2 Adjustable Wrenches
6. 1-
1/16” Wrench
2. MM / Inch Socket Set
7. Tape Measure
3. 24MM Wrench
8. Hammer or Mallet
4. 21MM Wrench
9. Lithium Grease
5. 18MM Wrench
10. Carpenter's Level
7
7. Tape Measure
16.
3/4” x 36” Long Rebar
REQUIRED TOOLS
BEFORE YOU START
Identify and inventory all parts using the checklist boxes that appear on
each page. Be sure to keep the hardware bags and their contents
separate. If any parts are missing call Our Customer Service Department
(800-243-0533).
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE AND WILL VOID THE WARRANTY.
●
A minimum of four adults are required to safely assemble the unit.
●
The major components of this system have considerable weight. It is recommended that
scaffolding and/or a lift jack be used to hoist the post, outrigger, braces and board into place.
●
If using a ladder during assembly, use extreme caution. Follow all warnings and cautions on the
ladder carefully.
●
A probability of serious injury exists if this system is not installed, maintained, or operated
properly.
●
Before digging, contact the appropriate agency to locate underground power cables, gas, and
water lines. Do not install the system within 20 feet of overhead power lines.
●
Climate, corrosion, or misuse could result in system failure.
●
If technical assistance is required, contact the manufacturer.
●
Most injuries are caused by misuse and /or failure to follow instructions.
●
Use caution when using the system.
!
!
SAFETY INSTRUCTIONS
