Getting started
Power on/off and pairing
To power on, press and hold the multi-function button for 2 seconds until the operation LED lights up in white.
The headphones enter pairing mode automatically as the operation LED flashes quickly in red and white.
To pair, go to Bluetooth
®
settings on your device and select “JAYS q-Seven Wireless”. The operation LED will
flash slowly in white upon a successful connection.
To power off, press and hold the multi-function button for 5 seconds. The operation LED flashes once in red
and then in both red and white before the headphones powers off. If the Bluetooth
®
on the paired device
turns off, the headphones will turn off automatically after a few minutes.
Reconnecting and additional pairing
Next time you power on, the headphones will automatically try to reconnect to the most recently used device.
If not found, pairing mode will automatically be initiated again. If you manually disconnect the headphones from
the device, press the multi-function button once to enter the pairing mode. To force pairing mode, press and hold
the multi-function button for 3 seconds from off state. To clear the pairing history, press and hold the multi-function
button and button for 5 seconds. For more information and help on reconnecting and additional pairing,
please view the troubleshooting.
Using the NC button
To enter ANC mode, single click the NC button, the NC LED will light up in white.
To enter HearThrough mode, single click the NC button, the NC LED stays white.
To go back into ANC mode, single click the NC button, the NC LED stays white.
To turn off ANC or HearThrough, hold the NC button for 2 seconds, the NC LED turns off.
Using the audio cable
Connect the audio cable to the audio jack and your device. The device will automatically switch over from
Bluetooth to the audio cable.
Battery status and charging
The operation LED flashes quickly three times in red as the battery level is running low.
Charge by connecting the included USB cable to the USB jack on the bottom of the right ear cuff and
connect it to any certified USB power output. The operation LED will glow in red during the charging.
When the headphones are fully charged, the operation LED will glow in white for 10 seconds, then the
operation LED turns off. A full 100% charge will take around 2-3 hours (depending on temperature
and charger).
EN
English
Summary of Contents for q-Seven Wireless
