- 8 -
1. Fixing the wall bracket(B) to the wall 2cm-15cm over the shaft or intermediate bracket ,and should be center
horizontally. (depending on the actual installation space).
2. Fixing the steel track to the wall bracket using axis pin
Φ
8x80 (C) and cotter pin. (Fig. 5)
3. Fixing garage door opener to the track by U bracket(E). Then fasten using
Φ
6 flat washer,
Φ
6 spring washer and
M6 nut.
·
4. Fixing the hanging bracket(F) to the edge of the opener as in Fig. 5 using M6x16 carriage bolt(before fastening, cut
off any excess hanging bracket).
5. Fixing the opener on ceiling by hanging bracket.
Notice: Make sure the track is horizontal and vertical to the shaft. Make sure the connection of hanging bracket and
ceiling is firm enough.
6. Fix the door bracket(A) to the top edge of the door(should be in the middle and under the wall bracket)
7. Connect the bent arm(G) to the door bracket using a
Φ
8x25 axle pin and cotter pin as shown in Fig.5.
8. Install the shuttle(D) to the track using 4pcs of M6x20 screws(Fig.6), tie the clutch cord. Connect the straight arm(H)
to the clutch using a
Φ
8x25 axle pin as shown in Fig.5.
9. Connect the bent arm and straight arm using M8 outer hexagon bolt(before connecting, adjust the suitable length
of bent arm and straight arm).
10. Release the clutch, try to open and close the door by hand. Make sure there is no resistance between door panel
and track.
11. Connecting the opener with power and adjusting the operation.
Notice: Make sure the opener’s voltage is in accordance with the local voltage. Connect the opener to a properly
earthed power supply.
Assemble the Track(optional)
Fig.6
Fig.5
