- 3 -
protection system depending on contact with the bottom edge
of the door.
19. Drives, shall be supplied with a label suitable for permanent
fixing with a warning sign to keep children away when the door
is moving, having a height of at least 60 mm. Drives shall be
supplied with a label suitable for permanent fixing that
describes how to use the manual release.
20. Information concerning the adjustment of the door and drive.
21. The garage door opener emission sound pressure level of
the dri
ve is LpA ≤ 70 dB(A).
22. WARNING: the drive shall be disconnected from its power
source during cleaning, maintenance and when replacing parts.
23. The installation instructions shall include details for the
installation of the drive and its associated components.
24. If necessary, call for authorised service.
25. For drives supplied without a door, the installation
instructions shall indicate the type, size and mass of the garage
door leaf for which the drive is intended to be used and the
position(s) where the drive can be installed.
26. Before installing the drive, remove all unnecessary ropes or
chains and disable any equipment, such as locks, not needed
for powered operation. Before installing the drive, check that
the door is in good mechanical condition, correctly balanced
and opens and closes properly.
27. Install the actuating member for the manual release at a
height less than 1.8 m. If removable, the actuating member
should be stored in direct vicinity of the door.
28. Install any fixed control at a height of at least 1.5 m and
within sight of the door but away from moving parts.
29. Permanently fix the labels warning against entrapment in a
prominent place or near any fixed controls.
30. After installation, ensure that the mechanism is properly
adjusted and that the drive reverses or the object can be freed
when the door contacts a 50 mm high object placed on the floor
(for drives incorporating an entrapment protection system
depending on contact with the bottom edge of the door).
