JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 16 -
2.4 PATCH / Assigning DMX channels to the dimmer/PAR section
In analogy to the fixture section, the Patch menu is also used to assign DMX channels are assigned to
the dimmer/PAR section. Enter CONFIG menu and select the menu item PATCH. Press the PAR1 key
and the following display is shown:
The softkeys listed below have the following functions:
SCAN 1:
enters DMX addresses for fixture no. 1 – 16
SCAN 2:
enters DMX addresses for fiixture no. 17-32
AUX:
enters DMX addresses for AUX controllers
PAR1:
enters DMX addresses for dimmer channel 1-16
PAR2:
enters DMX addresses for dimmer channel 17-32
PAR3:
enters DMX addresses for dimmer channel 33-48
PAR4:
enters DMX addresses for dimmer channel 49-64
PAR5:
enters DMX addresses for dimmer channel 64-80
PAR6:
enters DMX addresses for dimmer channel 81-96
A/B:
selects the DMX output
CURVE:
selects the dimmer curve
CLEAR:
deletes all DMX addresses
OPEN:
deletes an individual DMX address
PATCH:
confirms data input
Left encoder wheel:
selects DMX addresses
Middle encoder wheel:
moves the cursor up and down
Right encoder wheel:
moves the cursor to the left and right
2.4.1 Entering DMX start addresses for the dimmer/PAR section
You can assign up to four DMX addresses to each Par key (1-32). Enter Patch menu and select PAR 1.
Use the middle or right encoder wheel to select the key in the Fixture-/PAR Selection, for which you wish
to enter DMX start addresses. Use the left encoder wheel to select DMX addresses.
Since the Licon 1X comes with two separate DMX outputs, select the DMX lines A or B by pressing the
softkey A/B.
Press the softkey PATCH to confirm the assignment of the channel.
After each confirmation with the softkey PATCH, the cursor jumps to the next position and the next not
occupied DMX channel is recommended automatically by the controller. You will only have to confirm with
PATCH.
2.4.2 Deleting particular DMX start addresses
To delete the DMX assignment of one particular key, select this key with the middle encoder wheel and
press the softkey OPEN.
2.4.3 Deleting all DMX start addresses
If you wish to delete all start addresses, enter
CONFIG/PATCH menu and press the softkey CLEAR. The
menu shown on the left appears on the display:
After you have pressed one of the the softkeys ALL, SCAN,
AUX or PAR, the deletion procedure starts immediately
without prior confirmation prompt. Press the ESC key if you do not wish to delete a start address.
ALL:
deletes all DMX start addresses
SCAN:
deletes start addresses of fixtues
AUX:
deletes start addresses of AUX controllers
PAR:
deletes DMX assignment of dimmer/PAR channels
Press the ESC key to leave this menu.
Summary of Contents for LICON 1X
Page 1: ...Bedienungsanleitung Version 2 1 ...
Page 2: ...JB lighting Lichtanlagen GmbH Sallersteigweg 15 89134 Blaustein Telefon 49 0 7304 9617 0 2 ...
Page 134: ...User manual Version 2 1 ...
Page 135: ...JB lighting Lichtanlagen GmbH Sallersteigweg 15 D 89134 Blaustein Telefon 49 0 7304 9617 0 2 ...
