ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
3/3
FIRE FOG
OPERATING INSTRUCTIONS
Put the fogger on a flat and very stable surface. Make sure that nobody can put their hands just in front of
the output. The fog is very hot and can cause serious burnings!!!
Make sure the fog liquid tank is not empty. Always use good quality fog liquid to fill up the tank. Close the
tank immediately to prevent dirt to enter the reservoir!
Make sure to plug the fogger in a mains wall socket with earth connection
Switch the fogger on (9) and wait for about 3 minutes. (warm up time)
When the LED of the remote control is lit (6) you can use the Fog output switch (7) to activate/deactivate
the fog production.
MAINTENANCE
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
Cleaning the fogger:
To prevent obstructions in the heater, pump and tubes, the fogger should be cleaned on a regular basis:
every 100h of continuous operation is a good reference.
Switch the fogger off
Remove the nozzle (metal part where the fog leaves the fogger)
Remove the fog liquid from the tank
Fill the tank with about 1liter of a solution containing 80% distilled water and 20% white vinegar.
Switch the fogger on and wait for about 8minutes (warm up time)
Put the fogger in continuous operation mode until the tank is empty
Put the nozzle back in place
Remove the eventual residues of the cleaning solution and refill the tank with fog liquid.
Remark:
cleaning should be done outside; an awful smell is produced by the vinegar solution!
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
This unit is radio-interference suppressed. This product meets the requirements of the current European and
national guidelines. Conformity has been established and the relevant statements and documents have been
deposited by the manufacturer.
This device has been designed to produce decorative effect lighting and is used in light show systems.
Mains Input:
AC 220-240V, 50Hz
Power consumption:
400 Watt
Fuse (size: 5x20mm):
250V /
5A
Warm up time:
2 à 3 min
Tank size:
0,5L
Fluid to be used:
Fog Liquid (JB Systems Standard or HI-Tech)
Fluid consumption:
4 ml/min
LEDs:
3x 3Watt (amber)
Size:
237 x 118 x 163 mm
Weight:
1,8 kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.jb-systems.eu
