2
- Place the handpiece on top of the new
cartridge, press it slightly down and remove
the handpiece.
Changing the handpiece's cartridge
With the Advanced system, the cartridge can
be changed quickly, without turning off the
station, so you have two soldering irons in one.
Here is what to do to change the cartridge:
1
- Place the handpiece and remove the
cartridge.
3
- Press the cartridge into the opening A, B or C:
A. For straight 2210 cartridges.
B. For curved 2210 cartridges.
C. For 2245 cartridges.
SLEEP FUNCTION
Tool in sleep mode
One of the Series Advanced features is that
when the tool is placed in the holder, the
temperature at the tip drops automatically to the
sleep temperature (sleep). This function is only
possible because of the quick response time
which does not make the user realise the
temperature rise to reach the selected
temperature. Thanks to the sleep mode, oxidation
levels at the tip are much lower and therefore tip
life extended to 3 to 5 times under equal
conditions of use.
To indicate that the tool is in sleep-mode, the yellow
light in the control unit remains permanently lit.
These parameters can be modified using the
AC 2600 console
Ref. 2600000.
In order to take full advantage of the sleep
function and as a security measure, it is
necessary to place the tool in the stand
when it is not being used.
Alignment
XX
XXXXX
Important.
-
It is essential to insert the cartridge till the
end for a good connection. Take the mark
as reference.
5
ENGLISH
The tip life is directly related to the
temperature and time . With a greater
temperature for a longer time, the tip duration
is reduced in an exponential form.
Due to this, it is advisable to keep the soldering
iron in the support at sleep temperature (200ºC
approximately) to increase the tip life.
Summary of Contents for AD 2700
