ENGLISH
5
Desoldering process
Use the tip model with a larger diameter than the
pad to be desoldered, so as to achieve maximum
aspiration and thermal efficiency.
1
Apply the desoldering iron tip so that the
component terminal penetrates within its
orifice.
2
When the solder liquefies, start gently to rotate
the desoldering tip so that the component’s
terminal can be eased away from the sides.
3
Press then, not before, the vacuum pump
push-button just long enough to aspirate the
solder.
After pressing the desoldering key there is a
slight delay until the self-contained vacuum
pump stops, this is to make sure that the
vacuum circuit is completely empty.
If any solder remains are left on any terminal after
attempting to desolder it, resolder it with fresh
solder and repeat the desoldering operation.
1
2
3
Ref. 5600-001
5600-002
5600-003
5600-004
5600-005
5600-006
5600-007
5600
A
ø (mm)
B
ø (mm)
max. pin ø
(mm)
001 / 011
1.4
0.6
0.4
002 / 012
1.8
0.8
0.6
003 / 013
2.7
1
0.8
0 0 4
3.2
1.3
1.1
0 0 5
3.4
1.6
1.4
0 0 6
4.2
2
1.7
0 0 7
4.8
2.5
2.3
A
ø
B
ø
5600-012
5600-013
5600-011
DESOLDERING TIPS
These tips are
specially designed
to clean the pads.
Summary of Contents for advanced Series
Page 83: ...ITALIANO 83 ELECTRIC WIRING DIAGRAM...
Page 84: ......
Page 85: ...ITALIANO 86...
Page 86: ...ITALIANO 87...
