2
ENGLISH
7
. Take the solder thread from the solder reel until
the guide tube start.
Place the control in the indicated position in order
to close the dragging mechanism.
Dragging system's wheel replacement
If you uses solder threat diammeter within1,1 and
1,5 you must use guide set
ø1,1-ø1,5
Ref.
0002843.
This accessory is supplied with a wheel for the
dragging system Ref. 0002863. The wheel must
replace the one that is supplied with the station,
eventhough when only threat diammeter 1,5mm
are will be used.
In order to replace it, you only need to move to the
right side the opening command of the dragging
system and separate the wheel from its place at
the same time. Place the new wheel and put the
command at its initial position.
7
7
Thread dragging
button
Fast dragging thread
Connect the handpiece to the station and switch it
on. Press the WIRE LOAD key (Fast dragging
thread) till the solder leaves by the end of the guide
tube. Display will show the message "LOADING
SOLDER WIRE".
Ref. 0002863
Summary of Contents for AL 2500
Page 1: ...AL 2500 GUIDE SETS FOR Index Page English 1 Español 3 Deutsch 5 Reference Guide ...
Page 2: ......
Page 4: ......
