3
1
4
2
7. Cartridge Insertion and Charging
Place the tool over a cartridge
and press the tool down to insert
the cartridge (1). To release the
tool with the cartridge from the
extractor, lift the tool upward (2).
Make sure that the cartridge is
appropriately inserted* into the
tool by gently pressing the tip
against the holes on the sides
of the cartridge exchanger (3).
*Important:
Cartridges must
be inserted up to the mark for
a proper connection.
Place the tool on the tool holder
(4) to charge it. A beep will
sound to confi rm that the tool
is properly placed and charging.
The sound can be turned up,
down or off using the buttons
on the display.
Note:
Charge the tool
completely before using it
for the first time. It will take
aprox. 60 min for B210, aprox.
30 min for B115 and aprox. 40
min for BP115.
For more information on how to change cartridges and the use of the cartridge exchanger, see section
“Cartridge Exchanger and Cartridge Holder”.
Inserting
Fixing
Charging
Mark
ø 1
ø 1,5
ø 3,5
8
B210 Handle works with C210 Cartridges. Find the model that best suits your soldering needs at
www.jbctools.com
Conical
Chisel
Conical
Bent
Bevel
Compatible Cartridges
