10
CD-SC /
PRECISION SOLDERING STATION
MAINTENANCE
Before carrying out maintenance or storage, always allow the equipment to cool.
- Replace any defective or damaged pieces. Use original JBC spare parts only.
- Repairs should only be performed by a JBC authorized technical service.
- Maintenance shall not be carried out by children unless supervised.
Remove the fuse by pulling the black cap. Help
yourself with a lever tool if necessary.
Place the new fuse into the holder by pushing
and enter it again into the station.
Clean periodically
- Clean the station’s screen with a glass cleaner or
a damp cloth.
- Maintain tip surface clean and tinned prior to storage in order to avoid tip oxidation.
Rusty and dirty surfaces reduce heat transfer to the solder joint.
- Periodically check all cables and tubes connected.
- Replace the fuse if it is blown according to the following guidelines:
- Use a damp cloth to clean the case and the
tool. Alcohol can be used only to clean the
metal parts.
- Check periodically that the metal parts of the
tool/stand are clean in order to have a good
detection when the tool is in the stand.
