jbc CDEB, Instruction Manual

CD-Q:

OK

CD-Q:

OK

CD-Q:

OK

Changing the Grips

Put the slide-on tabs into the 
new grip.

Hold the grip and pull the tab. 
Use pliers if necessary.

tabs

new grip

Replace the grips easily using the slip-on tabs. 

Note: 

Choose the correct grip depending on your handle 

model.

1. Inserting Tabs

2. Inserting Handle

3. Removing Tabs

The sealing plug prevents undesirable flux vapors or particles from entering inside the tool. Its usage 
is highly recommended for intensive applications when soldering is exposed to FOD environments or 
for applications where the soldering iron works close to vertical position. 

Note:

 Choose the correct 

sealing plug depending on your handle model.

Sealing Plug Replacement

     Before replacing the sealing plug, unplug the power supply and make sure the device is not hot. 

Note:

 The chamfered side has 

to be positioned towards the 
handle. 

2. Mounting Position

3. Inserting Sealing Plug

1. Removing Sealing Plug

Sealing 
Plug

Handle

Push the sealing plug inside 
the handle until the sealing 
plug and handle edges are 
aligned.

Enter, not deeper than 8mm, 
a small shaft or screwdriver, 
lift and pull the sealing plug. 
Never use a cartridge to do 
this operation. 

Handle ref.:  

T245-A / T245-C / T245-GA    T210-A / T210-NA         T245-PA 

      T210-PA

Grip ref.:

               0016057 (green) 

        0018658 (green)      0021528 (blue)     0023310 (blue)

Handle ref:

T245 / T470 

   T210            

Sealing plug ref.:      

OB2000                 OB1000

Push the grip with the tabs 
onto the handle. 

6