Tools
?
17:14
T245 - port 3
Cartridge Adjust
C245-003
Temperature adjust
0ºC
Temp. level set
Off
Sleep delay
0 min.
USB flash drive is connected.
Station is controlled by a PC.
Station is controlled by a robot.
Station software update.
Press INFO to start the process.
System notifications
Warning.
Press INFO for failure description.
Error.
Press INFO for failure description,
the type of error and how to proceed.
Indicates there is a peripheral to be
installed.
Insert the cartridge model and the station will recognize its characteristics (size and shape) to provide
better temperature precission.
Cartridge Adjustment
The following icons will be displayed on the screen’s status bar.
After inserting
the cartridge,
introduce
the last 3
numbers of
its reference.
Desoldering process
Use a tip with a larger diameter than the pad to achieve maximum aspiration and thermal efficiency.
Place the tip over the
lead.
If any solder remains are left
on a terminal after desoldering it, resolder it with fresh solder and
repeat the desoldering operation.
When the solder
melts, gently move
the tip in a circular
motion.
Press and hold the
tool button to start the
suction and continue
the movement
completing 3 o 4
circles.
3. Aspirating
1. Placing
2. Rotating
4. Removing
Remove the tip
while maintaining
the suction to make
sure all the solder is
removed from the
joint.
If desoldering tips does not provide enough heat to desolder leads from ground planes, consider
using a preheater PCB
.
10
