Maintenance
Before carrying out maintenance or storage, always unplug the tool.
- Check periodically that the metal parts are clean to ensure it is detected when on the stand.
Always use a damp cloth or alcohol.
- Periodically check all cables and tubes connections.
- Replace any defective or damaged pieces. Use original JBC spare parts only.
- Repairs should only be performed by a JBC authorized technical service.
Glass Solder Collector Maintenance
2.
Next remove the spiral and clean the inside
part of the collector with the cleaning stick.
- Check the filter and replace it if it is dirty or
damaged.
1.
For cleaning, the top must be unscrewed with
the DR560 in a vertical position.
3.
Insert the filter and the spiral filter which must
be inserted in place between the 2 lines on the
solder collector.
Before placing, make sure to insert the internal
gasket into the solder collector.
Finally screw on the top to close the unit.
Check filter
Check
internal joint
2
3
1
6
