4
ENGLISH
There are different models of protectors and
extractors as accessories.
The measurements of all the extractors and
protectors are given on page 34 of instructions
manual.
C) Tripod:
For small components for which an extractor
cannot be used, we recommend use of tripod 20
Ref. 0932050, as shown in the figure.
Use the tripod 40 Ref. 0932250 for larger integrated
circuits.
SOLDERING PROCEDURE
1 After desoldering the component, any solder
left on the printed circuit should be removed
using a desoldering station. We recommend
one of our stations, the
RP 5100,
the
RA 5150
or the
TA 5120
station.
2 Place the component or printed circuit.
3 When the component is correctly placed,
solder its pins.In the case of integrated circuits
of the Flat Pack type, first solder one pin of
every IC angle to fix it in place in the circuits.
4 Apply Flux
FL9582
in pads and leads.
5 Solder the remaining pins. For that, we
recommend you use our soldering station,
the Advanced Series, which has 2 models
of irons.
Summary of Contents for JT 6040
Page 33: ...ELECTRIC WIRING DIAGRAM...
Page 34: ......
