5
Changing PCBs of the same batch
Loosen one sliding guide, pull back and lift
out the PCB.
The support lets you place PCBs of the same batch so as to always heat the same area.
Use the sliding guides to change the PCBs.
Position it and tighten the sliding guide knobs.
Removing the PCB
Placing another PCB
Cap
Guide
PCB
Use the 4 caps to place larger PCBs than the PHB-SA Support or over 3mm thick.
1.
Remove both guides by
untightening the 8 screws.
2.
Place the PCB on the 4
rubber caps.
3.
The PCB is ready to work.
Reworking large PCBs
Clamp knobs
www.jbctools.com
