jbc Premium DIT-1D, Manual

13

Before carrying out maintenance or storage, always 
allow the equipment to cool and unplug the stand from 
the station and the tool

- Clean the station’s screen with a glass cleaner or a 

damp cloth.

- Use a damp cloth to clean the casing, the stand and 

the tool. Alcohol can only be used to clean the metal 
parts.

- Check periodically that the metal parts of the tool/

stand are clean so that the station can detect when 
the tool is in the stand. 

- Maintain tip surface clean and tinned prior to storage in order to avoid tip oxidation. Rusty and 

dirty surfaces reduce heat transfer to the solder joint.

- Periodically check all cable connections.

- Replace the fuse if it is blown according to the following guidelines:

Remove the fuse by pulling the black cap.  
If necessary use a tool to lever it off.

Press the new fuse into the holder and 
replace it in the station.

Maintenance

Fuse

- Replace any defective or damaged pieces. Use original JBC spare parts only. 

- Repairs should only be performed by a JBC authorized technical service.

Clean periodically

www.jbctools.com