ø 1
ø 1,5
ø 3,5
A
A
B
A
ø
B
ø
20
21
T245 Changing Cartridges
1. Removing
2. Inserting
3. Fixing
Place the handle in the
extractor and pull to
remove the cartridge.
Place the handle on top of
the new cartridge and press
down slightly.
Use the holes for fixing the
cartridge* as follows:
A.
For straight C210.
B.
For curved C210.
C.
For curved C245.
D.
For straight C245.
*
Important
It is essential to insert the cartridges as far as the mark for a proper connection.
B
C
A
D
Compatible cartridges
The T245 handle works with C245 cartridges. Find the model that best suits your soldering needs
in
www.jbctools.com
Round
Chisel
Round bent
Bevel
Special models
Save time and change cartridges safely without switching the station off.
DR560 Changing Tips
This operation should be done while the tip is hot, not below 250°C, so that any tin left inside is in
molten state.
250ºC minimum
C560-001
C560-002
C560-003
C560-004
C560-009
C560-014
C560-001
ØA=1,4 ØB=0,6 Ømax. pin=0,4
C560-002
ØA=1,8 ØB=0,8 Ømax. pin=0,6
C560-003
ØA=2,7 ØB=1 Ømax. pin=0,8
C560-004
ØA=3,2 ØB=1,3 Ømax. pin=1,1
C560-009
ØA=5 ØB=1,3 Ømax. pin=1,1
C560-014
ØA=2,5 ØB=0,8 Ømax. pin=0,6
1. Removing
Unscrew the tip using the spanner
supplied.
2. Inserting
Fit the new tip and tighten with the
spanner to make sure it is air tight.
Compatible Tips
The DR560 works with C560 tips. Find the model that best suits your soldering needs in
www.jbctools.com
Here are some C560 tips in real size (in mm):
Mark
www.jbctools.com
