4.
Running Your Binding machine.
WOB3500/Corinne/MesDocuments/Notices/WOB3500/Anglais
15
Spool or Cut length
To come back to previous screen
To go to next screen
Cancel the initialization
NOTA : If you select n°18 or n°20, put the bar
u
nder the jaws, fix it on the pusher, just clip the bar.
Don’t forget to remove it when you select under n°18
It is highly recommended that only original James Burn International Wire-O
®
spools are use with your WOB3500
binding machine.
Switch on the WOB3500.
On the opening screen using the ‘change switch’ select ‘spool’.
NOTA : Pressing the ‘change switch’ alternates between ‘Spool’ and ‘Cut Lengths’.
‘Cut Lengths’ should only be selected if you are using Wire-O in cut lengths supplied by James Burn International.
Select the wire-o size (see chart page 14)
select the number of loops
select the number of cut lengths
select the jump length between the cut lengths
In 3/1 pitch number of loops from 8 to 41, number of cut lengths 1 to 4, jump length 03 to 25 (loops)
In 2/1 pitch number of loops from 5 to 28, number of cut lengths 1 to 4, jump length 02 to 18 (loops)
After selection validate your choice by the key
New : WARNING
The screen displays
If you see this symbol (with buzzer) you must Remove the bar under the jaw.
Replace the wire, if necessary, from the dented wheel/cut assembly, press on to continue and initialize the machine
The screen displays
Engineer menu
Validate
