4.
Running Your Binding machine.
WOB3500/Corinne/MesDocuments/Notices/WOB3500/Anglais
20
NOTA : be carefull to bring the
wire up to the dented wheel to
allow a good wire supplying
When you have inserted the wire , close the cover of the wire drive and knife assembly.
Always place the small loop of the wire on the top
Take the end of the wire element and feed
it up to the bottom wheel of the wire feed
drive. Operate the spring loaded switch
upwards. The wire feed motor will start to
feed the wire up to the wire reservoir on
the top of the machine. Turn the spool by
hand to avoid the wire to be disformed.
Wire reservoir.
Spring
loaded
switch.
Wire feed
drive.
Lowering the wire into the jaw, the1
st
loop must be positioned as shown above
Drive wheel
Anvil
Cutter
