7.
Maintaining your Binding Machine
WOB3500/MesDocuments/Corinne/Notices/WOB3500/Anglais
24
General Maintenance
Although only limited maintenance is required, that which is required is important to
enable continually safe and good machine performance.
CAUTION
All maintenance work should be carried out by qualified personnel
maintenance engineers, service engineers, or electricians only
.
.
Before commencing any maintenance work, switch OFF the machine and
disconnect the electrical supply from the mains supply.
Daily Maintenance
The following daily maintenance is required:
Brush off loose wire coatings and deposits from the area around the Cutter, wire
transport and binding mechanisms.
Check that switches, indicator lights and the stop switches are functioning
correctly.
Check that all safety switches function correctly.
Annual Maintenance
James Burn International recommends an annual service visit from our service
engineers.
Ongoing Maintenance
Change cutter and Anvil block as a pair, as and when
required,
