JBJ Picotope, Owner'S Manual

12 

HANDLING PRECAUTIONS 

Never attempt to move a full or partially full PICOTOPE. 

Never lift by grabbing the aquarium walls. 

Never use cleaners that contain ammonia to clean the glass surfaces. 

Always lift and carry the PICOTOPE from underneath giving support to 

the bottom at all times. 

CHOOSING A LOCATION 

Find a leveled surface that can support the weight of the tank, water, 

and livestock. An average aquarium can weigh 10lbs per gallon once 

filled with water, rock, gravel, and other accessories. 

Do not place in direct sunlight to prevent excessive algae growth and 

higher water temperatures. 

FILLING THE TANK 

Always dechlorinate tap water before adding into the aquarium. 

Always fill with room temperature water.  

Rinse Activated Carbon which is located in the rear filter compartment 

under the sink for 30 seconds or until water runs clear. 

Fill the main body of the PICOTOPE until water reaches the bottom of 

the clamp for the light fixture. Once PICOTOPE is filled, plug PICO pow-

erfilter power cord into an approved electrical outlet with a fuse or cir-

cuit breaker.  

Once filter is on, water will enter intake strainer through the filtration 

media and return back into the tank. 

ADDING A HEATER ( not included) 

If you wish to keep tropical (warm water) fish you will need a submersi-

ble heater to maintain optimal water temperatures to simulate their 

natural environment. Most tropical fish will need a temperature range 

between 74-78 F for optimal living conditions. 

A heater can be placed in the main body of the PICOTOPE behind 

accessories such as decorations, plants, or rocks.  

We recommend a small 100% submersible 25-50 watt heater if neces-

sary. 

Note: 

Evaporation occurs faster in smaller tanks that have open tops. Please 

check water level regularly to ensure filter is functioning properly