Amplifier P o w e r
Tne maximum recommended power input to tne low frequency
loudspeakers is 200 W continuous sine wave at an Impedance
of 4 n. and 100 W contiruous sire wave at 8 n into the high
freouency section Larger amplifiers car be employed
U
normal
precautions against input device distortion or amoifier clipping
are followed
Component Removal
To optimize the sound dispersion characteristics of the
loudspeaker system, maintain tne acoustical integrity of tne
enclosure and facilitate inspection and service ah components
mount directly to tne baffle pane! and are removable from the
front ol the enclosure
Loudspeaker system components ol the 4350 Studio Monitor.
It is recommended mat the enclosure be placeo on its back
when removing any of the components Removal of the left low
frequency loudspeaker is required when taking out the high
frequency or ultra-high frequency drivers; however, it is advisable
to remove both low frequency loudspeakers to provide
max,mum access to tne interior of the enclosure and as a
safeguard to prevent accidental damage whicn could occur to
tne right low frequency loudspeaker if it were left in place. When
converting the 4350 to the nght-nand configuration, removal of
both loudspeakers is necessary.
Lett-Hano Configuration
Right-Hand Configuration
Low Frequency and Midrange-The
low frequency and mid range
loudspeakers are eacn secured to the enclosure by four cast
clamps held in place by machine screws threaded into T-nuts
Each loudspeaker can be taken outof theenclosure Oy loosening
the mounting screws, removing the clamps and lifting the unit
from the enclosure. (If it is impractical to place the enclosure on
its back, a loudspeaker can be removed by loosening the four
mounting screws, swinging the upper clamps out of tne way. anc
then lifting the unit from the lower clamps ) Once a loudsoeaker
has been lifted a few inches from the baffle panel, the mout leaas
can oe disconnected at the terminals on its frame.
High Frequency-the
high frequency compression driver.
model
2 4 4 0 ,
is bolted to the exponential horn and support
bracket; the assembly is tnen installed in theenclosure. The horn
flange fits into a cutout provided on the baffle oanel fa white
vinyl ring gasket on the horn insures an airtight seal) and the
input terminals to tne 4350. Observe coisisieni polarity tor the iow and
high frequency sections ot the loudspeaker system.
installation of the high-frequency comp'ession driver and now are as
shown. Note orientation ot the support oracket a-id use ot lock washers
m each configuration.
