JBL Bar 5.1 Surround, Owner'S Manual

8

7. SOUND SETTING

This section helps you choose the ideal sound for your video or 
music.

Before you start  

•  

Make the necessary connections described in the user manual.

• On the soundbar, switch to corresponding source for other 
 devices.

Adjust the volume

•  

Press /- button to increase or decrease a volume 
level.

•  To mute sound, press MUTE button.
•  

To restore the sound, press MUTE button again or press 
/- button

Choose sound effect

1. Bass

  • 

Change low frequency (bass) settings of the soundbar.

    •  Press BASS +/- to change the subwoofer volume level.

  2. Sound mode

  q 2DKDBSOQDCDjMDCRNTMCLNCDRSNRTHSXNTQUHCDNNQLTRHB

  • 

Press SOUND button to select a sound option from the 
display panel.

  • 

Select the 

STANDARD

 mode if you want to enjoy the 

original sound. 

  • 

Select the 

MUSIC, MOVIE, VOICE, SPORT

 mode 

depending on the content you want to listen to.

  • 

When the wireless surround speakers are detached from 

SGDL@HMA@QRNTMCLNCDRED@STQDRODBHjBADG@UHNQR

Sound Mode 

 What you hear in the detached 

wireless surround speakers

      Standard 

Ambience and special effects

   Music 

Mono 

Mix

      Movie 

Ambience and special effects

   Voice 

Mono 

Mix

      Sports 

Ambience and special effects

  3. Night mode

  • 

For quiet listening, night mode decreases the volume of 
loud sounds when audio is played.

  • 

Night mode is only available for Dolby Digital or DTS 
soundtracks.

    •  Press NIGHT MODE button to turn night mode on or off.

Press and hold 5 seconds SOUND button to reset default  

 audio 

setting.

Synchronize video and sound

  • 

If the audio and video are not synchronized, delay the audio 
to match the video.

  • 

Press AUDIO SYNC +/- button to synchronize the audio  
with the video.

8. AUDIO CALIBRATION

Audio Calibration will optimize the wireless speaker sound settings 
for a better surround sound experience.
Remove the wireless surround speakers from the soundbar.

Connect the microphone into the connector on the right side of 
the soundbar. 

Place the microphone at ear-level at the listening position. For best 
surround sound effect, position the wireless surround speakers to 
the sides and slightly behind the listening area. 

Be sure to point the narrow side of the surround speaker towards 
the listening area, and remove any obstruction between the 
microphone and the wireless surround speakers.

Press and hold the calibration button for 3 seconds. The calibration 
sequence will begin with a countdown. 

>3 s

1

2

3

DONE