The battery should be replaced approximately every 2 years. This is
accomplished as follows:
•
Unscrew the two screws that hold the battery access cover in place. It
is located on the upper portion of the dividing network, on the rear of
the speaker enclosure (Figure 4).
•
Write today’s date, including the year, in this manual.
•
Install the battery by aligning the battery terminals with the mating
terminals in the network housing. Align male to female, female to
male terminals, then snap the connectors together, assuring a tight
connection.
•
Replace the battery access cover and install screws.
Battery Replacement Record
Date Installed:
No.
6
Battery Replacement
BATTERY
BI-AMP
High Frequency
Low Frequency
JBL INCORPORATED
8500 Balboa Blvd., Northridge, CA USA
NORMAL/
BI-WIRE
Figure 4 Battery Installation
final cg om 5-15 7/20/98 1:14 PM Page 10
