10
2.5 Output Wiring
To drive distributed speaker systems designed to operate at 70V or 100V, connect the
amplifier to a CST-2120 transformer module with the jumper cable that shipped with the
CST-2120 transformer module, see Figure 2.5.1.
JBL recommends using pre-built or professionally wired, high-quality, two-conductor, heavy
gauge speaker wire. Speakers wires should be twisted cable, if possible. To prevent the
possibility of short-circuits, the wires should be stripped back no greater than 6 mm (1/4
inch), see Figure 2.5.2.
Suggested below are guidelines to select the appropriate size of wire based on the dis-
tance from amplifier to speaker. Check with local code as this may vary.
Distance
Wire Size
Up to 25 ft. (7.6m)
16AWG
26-40 ft. (7.9-12.2m)
14AWG
Figure 2.5.1 Connecting To a CST-2120 Transformer Module
NOTE:
If driving a 70V or 100V distributed speaker system, use the optional CST-2120
transformer module (see Appendix A).
输出
输出
TO
Speaker
TO
Speaker
Figure 2.5.2 Connecting to Speakers
Summary of Contents for CSA-2120
