Figure 5.
Mounting the
tweeter using the I-Mount
flush-mounting kit.
Figure 6.
Aiming the tweeter
at a desired listening
position.
Figure 7.
Mounting the
tweeter using the I-Mount
surface-mounting kit.
INSTALLATION
CONNECTIONS
1)
push in
2)
turn
3)
4)
–
+
red
blk
1. Slide screw up or
down to adjust
tweeter angle.
4. Securely tighten
the large hand nut.
2. Tighten nut and
washer to lock
angle settings.
3. Rotate to aim
angled tweeter
toward listener.
1
2
–
+
red
blk
Open the crossover housing by firmly squeezing the sides of
the top half and lifting it away from the bottom. Using screws
or a wire tie, mount the crossover using the holes provided.
Observing proper polarity, connect the speakers and amplifier
as shown in Figures 8A and 8B. Replace the cover when you
are finished making the connections and adjustments (see
following section).
Figure 8A.
Wiring connections on the crosssover network
(shown with cover on).
Figure 8B.
Locating wiring connections
on the GTO506c woofer. Other woofers
are wired similarly.
To AMPLIFIER
SPEAKER OUTPUTS
To WOOFER
To TWEETER
Red
Blk
Big Lug =
Small Lug =
