background image

All features and specifications are subject to 
change without notice.

† The maximum recommended amplifier power 

rating will ensure proper system headroom to 
allow for occasional peaks. We do not recom-
mend sustained operation at these maximum 
power levels.

* Dolby and Pro Logic are trademarks of 

Dolby Laboratories.

DTS is a registered trademark of 
Digital Theater Systems, Inc.

HTI6

Frequency Response 

38 – 20kHz (–10dB) 

Recommended Maximum
Amplifier Power †

100 watts 

Impedance

8 ohms nominal 

Sensitivity

88dB (2.83V/1m)

Crossover Frequency

2,500Hz

Woofer 

6-1/2" polymer-coated aluminum
cone w/rubber surround

Tweeter

1" pure-titanium dome,
w/Elliptical Oblate Spheroidal™
(EOS) waveguide, and swivel
mount

Plate Size (W x H) 

8-1/2" x 11" (216mm x 279mm)

Mounting Cutout Size (W x H) 

7-1/8" x 9-11/16" (181mm x 246mm)

Mounting Depth 

3-7/8" (98mm)

HTI8

Frequency Response 

30 – 20kHz (–10dB) 

Recommended Maximum
Amplifier Power † 

120 watts 

Impedance

8 ohms nominal 

Sensitivity

90dB (2.83V/1m)

Crossover Frequency

2,500Hz

Woofer 

8" polymer-coated aluminum
cone w/rubber surround

Tweeter

1" pure-titanium dome,
w/Elliptical Oblate Spheroidal™
(EOS) waveguide, and swivel
mount

Plate Size (W x H) 

10-1/8" x 13-1/8" (257mm x 333mm)

Mounting Cutout Size (W x H) 

8-7/8" x 11-13/16" (225mm x 300mm)

Mounting Depth 

4" (102mm)

HTI6C

Frequency Response 

40 – 20kHz (–10dB) 

Recommended Maximum
Amplifier Power † 

100 watts 

Impedance

8 ohms nominal 

Sensitivity

88dB (2.83V/1m)

Crossover Frequency

2,000Hz

Woofer 

6-1/2" polymer-coated aluminum
cone w/rubber surround

Tweeter

1" pure-titanium dome,
w/Elliptical Oblate Spheroidal™
(EOS) waveguide, and swivel
mount

Plate Size (Diameter) 

9-3/16" (233mm)

Mounting Cutout Size (Diameter)

7-7/8" (200mm)

Mounting Depth 

4-1/4" (108mm)

Declaration of Conformity

We, Harman Consumer International

2, route de Tours 
72500 Chateau-du-Loir
FRANCE

declare in own responsibility, that the products described in this
owner’s manual are in compliance with technical standards: 

EN 50081-1:1992
EN 50082-1:1992

Steen Michaelsen

Harman Consumer International

Chateau-du-Loir, FRANCE. 9/00

D E S I G N   G O A L :

Combine the superior performance of traditional 

JBL loudspeakers with the convenience of in-wall installation.

T W E E T E R   T Y P E :

Pure-titanium dome with EOS™ waveguide, 

and swivel mount

W O O F E R   T Y P E :

Polymer-coated aluminum cone with rubber surround

C R O S S O V E R   N E T W O R K :

Straight-Line Signal Path™ (SSP)

P R O F E S S I O N A L   R E F E R E N C E :

Studio Monitor

O W N E R ’ S   G U I D E

P R O D U C T L I N E :

M O D E L S :

HTI6, HTI8 and HTI6C

Home Theater In-Wall Series

S P E C I F I C A T I O N S

©2000 JBL, Incorporated. 

JBL is a registered trademark of JBL, Incorporated.

Part No. 170-0033

P R O   S O U N D  
C O M E S   H O M E

JBL Consumer Products

250 Crossways Park Drive, Woodbury, NY 11797

8500 Balboa Boulevard, Northridge, CA 91329

800-336-4JBL (4525) (USA only)  

www.jbl.com

NOTE:

For new-construction applications, be sure 

to purchase the correct rough-in frame kit.

Summary of Contents for HTI6









Reviews: