These specifications are subject to change without notice.
9
Pairing
By default, all JBL on stage
TM*
II systems work on the same "RF channel." If more than one JBL on stage
TM*
II
Remote
control is within range of the speaker unit, multiple remotes would be able to control the speaker unit. If this
is not
desirable, the speaker unit must be paired with a unique remote. Pairing allows only one remote to control the
speaker unit.
To Turn Pairing On
Press the Pairing switch on the bottom of the
JBL on stage
TM*
II unit by inserting a paper clip or similar
device. Then press any button on the Remote within 5
seconds to associate that particular remote with the unit.
To Turn Pairing Off
Press the Pairing switch on the bottom of the
JBL on stage
TM*
II unit by inserting a paper clip or similar
device. Hold the paper clip or similar device for about 5
seconds. DO NOT press any buttons on the Remote
Control. After about 5 seconds, the unit will respond to
any JBL on stage
TM*
II remote control.
Remote Control Technical Specifications
- Transmission: Radio Frequency
- Frequency: 433.92 MHz
- Operating Range: Up to 20 ft.
- Battery: CR2032 3V
- Dimensions: 2-3/4" x 1-1/4" x 1/2".
- Weight (Including Battery): 0.8 oz.
Battery Replacement
The JBL on stage
TM*
II remote's battery should
last
a year under normal usage. To replace the
bat
tery, open the remote control unit by removing
the three small screws in the back of the remote,
and replace the old battery with a CR2032 type
battery or equivalent.
Pairing Button
Troubleshooting
If JBL on stage
TM*
II is not responding to the remote's
commands, check for the following possible problems and
solutions.
Possible Problem
No power to the
system
Remote switch in a
lock position
iPod® player does not
recognize the
remote's commands
Solution
Ensure that the correct power supply is
connected to JBL
o
n stage
TM*
II. Ensure
that the power button is pushed inward
and the green LED is lighted.
Ensure the side Hold switch is in the
position that prevents the orange dot
from being visible.
Turn the JBL on stage
TM*
II off and
undock
the iPod® player. Wait for 30
seconds.
Dock the iPod® again and
turn the JBL
on stage
TM*
II on.
