UK
4. Collection cap to prevent CO
2
loss
5. CO
2
hose
JBL ProFlora T3
6. Holding clip with suction pad
Taifun M: 4 x
Taifun S: 1 x
Installation
• First thoroughly rinse the reactor in lukewarm water. Do not
use detergents.
• Fit the reactor vertically in the aquarium in a position where
there is a gentle current. The upper edge of the device should
be at least 2 cm under the surface of the water.
• Connect the CO
2
hose to the CO
2
source. With bio-CO
2
systems
(e.g.
JBL Proflora bio80 und bio160
) to the hose connection
of the reaction vessel. With systems using pressurised gas
cylinders to the hose connection to the pressure regulator.
First let a few bubbles run through the device.
• At first the bubbles will flow intermittently through the spiral
bubble channel from the bottom to the top.
The device
needs approx. 48 hours to set up.
After 48 hours a bio-film
will have formed, allowing the bubbles to rise freely upwards.
As they rise, the bubbles will become smaller as a sign of
the diffusion of the CO
2
into the surrounding water. Once the
bubbles are at the top, they reach the collection cap where
any remaining CO
2
can diffuse completely.
Summary of Contents for ProFlora Taifun S
