5
MOUNTING OPTIONS
On shelves.
On the wall. Wall
brackets are included.
On optional stands.
SATELLITES AND SURROUNDS
Prepare the speaker wire as
described on page 7. Thread
the two conductors through
the two holes in the stand
bracket. Make sure to pre-
serve the proper polarity
(+ and – connections) by
threading the positive con-
ductor through the hole on
the left, and the negative
conductor through the hole
on the right looking at the
front of the stand. Push down
on the red speaker terminal
and insert the bare end of the
positive wire into the hole
under the red cap. Release
the cap, and tug gently on the
wire to make sure that the
connection is snug. Follow
the same procedure to con-
nect the negative wire to its
terminal.
Gently pull the slack out of
the wire and screw the shelf
stand onto the back of the
speaker in two places, as
shown. The shelf stand
screws may be found in
Hardware Bag A. Use the
larger screw in the upper
screw hole, and the smaller
screw in the lower screw hole.
ATTACHING THE SHELF STAND TO THE SPEAKER
+
—
MOUNTING THE SATELLITES ON OPTIONAL FLOOR STANDS
Important Safety Note:
The
supplied floor stand adaptors
facilitate installation with a
variety of general purpose
floor stands available from
many manufacturers. Since
different stands will have
different weight capacities
and stability characteristics,
it is the customer’s responsi-
bility to check with the stand
manufacturer or dealer
whether that specific stand
is capable of handling the
weight and proportions of
these loudspeakers in a safe
and stable manner. JBL dis-
claims any liability for the
selection of suitable floor
stands and/or correct com-
patibility between the
selected stand and these
satellite loudspeakers.
The floor stand adaptors are
compatible with floor stands
equipped with a 1/4"-20
threaded insert.
Prepare the speaker wire as
described on page 7. Thread
the two conductors through
the two holes in the floor
stand adaptor. Make sure to
preserve the proper polarity
(+ and – connections) by
threading the positive con-
ductor through the hole on
the left, and the negative con-
ductor through the hole on
the right looking at the front of
the adaptor. Push down on
the red speaker terminal and
insert the bare end of the
positive wire into the hole
under the red cap. Release
the cap, and tug gently on the
wire to make sure that the
connection is snug. Follow
the same procedure to con-
nect the negative wire to its
terminal.
Gently pull the slack out
of the wire and screw the
+
—
