JBL Synthesis
System
Configuration
34
Restoring the original parameter values of an Effect
The RESTORE PARAMETERS function allows you to restore the
currently selected Effect to its factory preset state. When you select this
function, you will be prompted to reconsider erasing your changes. If you
don’t want to erase your versions, press DONE to exit the menu.
Pressing SELECT in response to the displayed query will restore all of
the factory preset values to the Effect.
Naming your custom Effect
EDIT EFFECT NAME allows you to assign a new name, of as many as
13 characters, to your Effect. With EDIT EFFECT NAME highlighted,
press SELECT to display the current name with a cursor indicating
which character position can be modified. SELECT moves the cursor to
a new position.
▲
and
▼
scroll through the available character set.
Press DONE to save the new name.
Restoring the original Effect name
RESTORE EFFECT NAME allows you to restore the original factory
name of an Effect, without changing any of your modified parameter
settings. When you select this function, the message PRESS SELECT
TO RESTORE EFFECT NAME allows you to reconsider erasing your
custom name. — If you don’t want to erase your version, press DONE
to exit the menu. Pressing SELECT in response to the displayed query
will restore the factory preset name.
Listening to only the SDP-3 Effect
Selecting EFFECT ONLY allows you to listen to only the effects added
by the SDP-3 to the currently loaded program. With this function
selected, use
▲
and
▼
to turn this function on or off.
Front/Back Fader
This control allows you to adjust the front/rear balance for the current
effect. This control can also be accessed on the remote by pressing and
holding the Shift button and using
▲
to move the balance point forward,
and
▼
to move it backward.
This menu item assigns the status for the remote trigger voltage that
appears on pin 5 of the DIN jack on the SDP-3 rear panel. +5VDC is
provided for controlling ancillary equipment or functions. This signal can
be enabled or disabled for the selected effect. +12VDC is available via
an internal jumper. Contact JBL Synthesis Customer Service to perform
this change.
When the SDP-3 is used with a JBL Synthesis 2.1/5.1 (Stereo/Multi-
Channel) system, enabling the remote trigger switches the left and right
front speakers into the 5.1 (horn) configuration. Disabling the trigger
puts the speakers into 2.1 (tweeter/midrange) configuration.
TRIGGERS
TRIGGERS
GND
PGM
PWR
IR IN
PGM GND PWR
1
2 4
3 5
PGM Trigger Assignment
1= Ground
2= Ground
3= Power On
4= Unused
5= Trigger
1 = Ground
2 = Ground
3 = Power On
4 = Unused
5 = Trigger
3
1
4
5 2
