6
Connections between the SDP-RFD AC-3
®
/RF Demodulator and associated
equipment should be made with all units UNPLUGGED!
POWER
Connect the AC adapter here. Use only
the supplied Synthesis MSA AC adapter.
INPUT
Connect a 5-pin DIN cord (not sup-
plied) from this input to the SDP-2
PWR CTL Output. This allows the
SDP-RFD to power on and off with
the SDP-2. If nothing is hooked up
here, the unit will turn on when-
ever the AC adapter is supplied
power. This set-up allows use of
a switched outlet or continuous
power. (As power consumption
and heat generation are both
minimal, this will not harm the
SDP-RFD.)
LOOP THRU
Allows the hook-up and power cycling of a
ditional components such as the Synthe
S Series of power amplifiers. Refer to
DIN configuration diagram below.
RF IN
Connect this input to the
output with a 75
Ω
coax
short as possible to min
1 = Ground
2 = Ground
3 = Power On (cons
when the DC-1 is On
4 = Unused
5 = Trigger (programma
POWER
9V~, 1A,
50-60Hz
JBL, INC.
NORTHRIDGE, CA 91329
MADE IN U.S.A.
SERIAL #
USE JBL
MSA AC ADAPTER
SDP-RFD AC-3
®
/RF
DEMODULATOR
PWR CTL
INPUT
LOOP
THRU
PWR CTL
3
1
4
5
2