Quitting DACS4:
• After a Complete Calibration
When you have accepted the last channel, DACS4 will automatically transmit all settings to the SDEC and those
settings will be burned to the nonvolatile FLASH memory.
[F6]: Quits DACS4
Follow the instructions on the DACS4 screen to quit the program. Remove the “Loader” utility disk from the
DACS4 computer and store it in a safe location at the installation site. All the usual admonitions about dust, heat
and humidity apply to the choice of storage location.
• Quitting When Some Channels Are Not Accepted
If you must terminate a session before you have completed calibration, press [F6]. You will be warned that quitting
before completion of the job will lose any settings you may have completed at this time. You will be given an oppor-
tunity to reverse your decision to quit. If you click [Cancel], you will be returned to the program. If you click [OK], all
settings will be discarded and the program will be terminated.
SDEC Maintenance:
• Using The Loader Utility
When you began the SDEC calibration process, DACS4 asked you to install the 3.5” floppy disk provided with the
SDEC. After calibration is complete, this disk will contain a file that contains all settings made to the SDEC during
calibration. Leave this disk at the installation site, using conventional precautions about dust, heat and humidity.
In the event the SDEC needs to be replaced, you will use this disk to load the calibration settings into the replace-
ment SDEC. To do this you will need a portable computer running Windows 3.xx or Windows 95. It must have an
available COM port and a high-density disk drive. Use the following procedure to load the settings.
1. With everything off, connect a standard DB9 (9-pin) cable between the computer’s COM port and the connector
located on the rear panel of the SDEC.
2. Turn on the SDEC.
3. Boot the computer to Windows.
4. Insert the disk.
5. Click on File, Run.
6. Type A:loader.
7. Press [Enter].
8. Wait patiently. When the settings have been successfully transmitted and burned into the SDEC memory, a
“DONE” dialog box will pop-up.
9. Turn everything off, remove the disk and return it to storage. Install the new SDEC.
4.7
CALIBRATION WALK-THROUGH
54
Summary of Contents for SYNTHESIS SDEC-1000
Page 1: ...SYNTHESIS SDEC 1000 2500 INSTALLATION GUIDE...
Page 2: ......