SPECIFICATIONS
Club WS1000
Club WS1200
10" (250mm)
12" (300mm)
Low-profile SSI Automotive Subwoofer
Low-profile SSI Automotive Subwoofer
Power Handling (RMS):
200W
250W
Power Handling (Peak):
800W
1000W
Sensitivity
@
2.83V/1m:
89dB
92dB
Frequency Response:
35Hz – 175Hz
27Hz – 175Hz
Impedance:
2 or 4 ohms (selectable)
2 or 4 ohms (selectable)
Voice-Coil Diameter:
2" (50mm)
2" (50mm)
Mounting Depth:
3-5/16" (83mm)
3-5/16" (83mm)
Overall Diameter:
10-9/16" (268mm)
12-1/4" (310mm)
Cutout Diameter:
9-1/2" (240mm)
11-1/8" (282mm)
A valid serial number is required for warranty coverage.
Features, specifications and appearance are subject to change without notice.
These products are designed for mobile applications and are not intended for connection to the mains.
HARMAN International Industries, Inc. 8500 Balboa Boulevard, Northridge, CA 91329 USA
www.jbl.com
© 2015 HARMAN International Industries, Incorporated. All rights reserved.
JBL is a trademark of HARMAN International Industries, Incorporated registered in the United States and/or other countries.
2-Ohm Setting
MOUNTING THE
SUBWOOFER
The Club WS1000 and WS1200 subwoofers
can be mounted from the outside of the
enclosure or from the inside of the
enclosure. Which- ever way you mount the
subwoofer, use the included foam
mounting gasket to ensure a leak-free
seal between the subwoofer frame and
the enclosure.
CONNECTING THE
SUBWOOFER
S
ETTING THE
I
MPEDANCE
The Club WS1000 and WS1200 subwoofers
both feature the Selectable Smart
Impedance
™
(SSI) switch. This exclusive
feature lets you set the subwoofer’s
impedance to either 2 ohms or 4 ohms
with the flip of a switch (see illustrations
to the right). This allows you to extract
the most from your subwoofer amplifier in
any situation.
The SSI 2-ohm setting increases the
subwoofer’s output over the 4-ohm
setting by up to 3dB, depending on the
amplifier. Performance is identical in all
4-Ohm Setting
other respects. If the connected amplifier
is rated for 2-ohm operation and its 2-ohm
power ratings are within the subwoofer’s
power-handling specifications, setting
the SSI switch in the 2-ohm position will
achieve maximum output.
IMPORTANT:
Make sure the
subwoofer amplifier is turned OFF before
setting the SSI switch. Do not change the
switch position while the subwoofer
amplifier is operating. Doing so could
damage the amplifier.
C
ONNECTING THE
A
MPLIFIER
The Club WS1000 and WS1200 subwoofer
connectors are compatible with quick-
disconnect (not supplied) or soldered
connections. The recommended wire gauge
is between 14AWG and 8AWG, depending
on the length of the wire run between the
amplifier and woofer. Heavier gauge wire
is preferred for runs over 6' (2m).
The wider terminal is the positive and the
narrower is negative (also indicated on
the terminal cover).
NOTE:
If using untinned bare wire, be
sure that no stray “+” and “–” strands
touch each other. Touching strands can
cause a short circuit, which can damage
your amplifier.
CLUB SUBWOOFERS
WS1000 and WS1200
EN
