Gateway C102/C112 Reference Guide Page 39
© JBM Electronics Co.
1-800-489-7781
www.jbmelectronics.com
key. You will get a short message saying that the changes were written.
To verify that the file format is correct, type
cat jbm.conf
If the file looks
correct proceed to the next section.
Note:
if you make a mistake while
entering that line hit the
<esc>
key and type
:q!
This will quit the editor
without saving the changes.
Testing the Auto Start Feature
The following procedure will verify that the jbm.conf modifications were
successful and that the application will auto start.
1. Type
sync;reboot
. This will reboot the Gateway. A typical reboot takes
about 30 seconds.
2. When the Gateway is finished rebooting, you will see the JBM Electronics
login screen. Login in with "root" as the ID and "gateway" as the password.
3. Type
ps ax
. This will show you a list of running processes. You
should see a line that includes the command you entered in the jbm.conf
file.
4.
If the ./gwlnx line is present in the list of running processes, type telnet localhost
5000. After logging into the telnet session, check the configuration name to be
sure that configuration name is the same one you have given it in the setup
program.
