C120/C300
Quick Start Guide
6
08/29/2008
•
Install the software that came with the aircard on a laptop.
•
Install the aircard into the laptop.
•
Follow the carrier provided procedures to properly activate the card, and
unlock the card if necessary.
•
Using the browser on the laptop insure that you are able to browse the
Internet.
3.
Resolve any and all signal/reception related issues with the aircard installed in the
laptop before installing the card into the JBM Gateway.
4.
Gently, insert the Aircard into the PCMCIA slot. Be sure it is firmly seated.
5.
Attach power supply connector to C120 and connect power supply plug to an AC
power outlet.
6.
Verify the PWR (yellow) LED is lit to indicate that the unit is receiving power.
7.
Establish access to the unit through Gateway Administration Utility.
Preparation C300
1.
Verify with your service provider that the SIM installed in the C300 is activated.
2.
Connect one of the antennas to the “Main” antenna port on the front of the C300.
3.
Attach power supply connector to C120 and connect power supply plug to an AC
power outlet.
4.
Verify the PWR (yellow) LED is lit to indicate that the unit is receiving power.
5.
Establish access to the unit through Gateway Administration Utility.
