Section 2-1 - Care and Safety
Safety Notices
Safety Check List
2-1-7
2-1-7
9803/3750-05 (2-01-01)
Operating Safety
!M
WARNING
Machine Condition
A defective machine can injure you or others. Do not
operate a machine which is defective or has missing
parts. Make sure the maintenance procedures in this
manual are completed before using the machine.
INT-2-1-2_2
!M
WARNING
Machine Limits
Operating the machine beyond its design limits can
damage the machine, it can also be dangerous. Do not
operate the machine outside its limits. Do not try to
upgrade the machine performance with unapproved
modifications.
INT-2-1-4
!M
WARNING
Engine/Steering Failure
If the engine or steering fails, stop the machine as
quickly as possible. Do not operate the machine until
the fault has been corrected.
INT-2-1-5
!M
WARNING
The engine has exposed rotating parts. Switch OFF
the engine before working in the engine compartment.
Do not use the machine with the engine cover open.
5-2-6-5
!M
WARNING
Exhaust Gases
Breathing the machine exhaust gases can harm and
possibly kill you. Do not operate the machine in closed
spaces without making sure there is good ventilation.
If possible, fit an exhaust extension. If you begin to
feel drowsy, stop the machine at once and get into
fresh air.
INT-2-1-10_2
!M
WARNING
You could be killed or seriously injured if you operate
a machine with a damaged or missing ROPS/FOPS. If
the Roll Over Protection Structure (ROPS)/Falling
Objects Protection Structure (FOPS) has been in an
accident, do not use the machine until the structure
has been renewed. Modifications and repairs that are
not approved by the manufacturer may be dangerous
and will invalidate the ROPS/FOPS certification.
INT-2-1-9_6
!M
WARNING
Work Sites
Work sites can be hazardous. Inspect the site before
working on it. Look for potholes, weak ground, hidden
rocks etc. Check for utilities such as electric cables
(overhead and underground), gas and water pipes etc.
Mark the positions of the underground cables and
pipes. Make sure that you have enough clearance
beneath overhead cables and structures.
INT-2-2-1
!M
WARNING
Communications
Bad communications can cause accidents. Keep
people around you informed of what you will be doing.
If you will be working with other people, make sure any
hand signals that may be used are understood by
everybody. Work sites can be noisy, do not rely on
spoken commands.
INT-2-2-3
!M
WARNING
Parking
An incorrectly parked machine can move without an
operator. Follow the instructions in the Operator
Manual to park the machine correctly.
INT-2-2-4_2
!M
WARNING
Banks and Trenches
Banked material and trenches can collapse. Do not
work or drive too close to banks and trenches where
there is danger of collapse.
INT-2-2-5
Summary of Contents for 535-125 Hi Viz
