Operation
Operating Environment
136
136
9811/9950-1
Operating in a Cold Climate (Below 0°C)
In extremely low temperatures special care should be
taken. Extend the warm up time and cover the front faces
of the radiator and oil cooler, after warm up remove the
covers.
1
Until the machine is thoroughly warmed up never
attempt to slew rapidly or operate the travel system,
otherwise damage may result.
2
Before operating the machine after warm-up, ensure
that the boom, dipper bucket, slew and travel services
all operate correctly. A time lag may occur when
selecting these services if the hydraulic oil is not
sufficiently warm.
3
If the machine is left outside for more than one day
without usage, remove the battery and take it indoors.
4
Drain the water collected in the fuel system to prevent
it freezing.
5
Clean the machine after use and place it on wooden
blocks. Keep rams as fully retracted as possible.
Wipe off any water from the exposed portion of the
piston rods.
6
Additional low temperature fuel and lubricants and
batteries may be required. Consult your local JCB
dealer for advice.
Operating in High Temperatures
T3-070
In high temperature situations, take the following
precautions to prevent possible damage to the machine.
1
Use the correct viscosity engine lubricating oil.
2
Use the correct coolant mixture.
3
Check the coolant system regularly, keep the coolant
at the correct level. Make sure there are no leaks.
HE Services
Summary of Contents for 8026 CTS
