Maintenance
Engine
98
9831/7750-1
98
Replace the Oil Filter
Figure 53.
A
A
Filter canister
1. Make the machine safe.
Refer to: Maintenance (Page 75).
2. Get the access to the engine compartment.
Refer to: Engine Compartment Cover (Page 90).
3. Drain the oil.
3.1. Put the suitable size of a container below the remote oil drain plug. Refer to Figure 52.
3.2. Remove the drain plug.
3.3. Remove and discard the O ring.
3.4. Let the oil drain out, then clean and install the drain plug with a new O ring.
4. Remove the filter canister, use a chain wrench if necessary. Refer to Figure 53.
5. Clean the seal face of the filter head.
6. Install the filter canister. Refer to Figure 53.
6.1. Smear the seal on the new filter canister with clean engine oil.
6.2. Screw the filter on until it just contacts the filter head.
6.3. Turn the filter at least a further 3/4 of a turn.
7. Through the top filler point, fill the engine with the recommended oil to the MAX mark on the dipstick. Wipe
off any spilt oil, refit the filler cap and make sure it is secure.
8. Operate the engine until the oil pressure low warning light has extinguished. Check for oil leakage. When
the oil has cooled, check the oil level again, and if necessary top up with clean engine oil.
9. Close the engine cover.
Drive Belt
Check (Condition)
Summary of Contents for CT160
