JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
adjustment knob counter-clockwise
and clockwise if belt runs inward
(See E). Adjust the belt until the
outer edge of the belt is even
with the outer edge of the base-
plate (13). Belt life will be greatly
increased by keeping the tracking
adjustment set properly.
7. DUST BAG (See F)
You must use the dust collection
bag provided to collect the dust
produced during sanding. The dust
collection bag plastic bracket slides
down onto the dust outlet on the belt
sander. When the dust collection
bag is full, remove and empty by
opening the zip on the dust bag (4).
8. DRIVE BELT
REPLACEMENT(See G)
WARNING! Remove the
main plug from the socket
before carrying out a drive belt
replacement.
Remove the three
screws (a) and the belt cover as
shown. Carefully cut the drive belt if
not already broken and remove from
your belt sander. Fit your new drive
belt around the large pulley. Then
install onto the small pulley by
rotating clockwise and pushing the
drive belt shown around the small
pulley at the same time. The drive
belt will be a tight fit. Fit the belt
cover and three screws.
E
13
6
F
4
5
a
G
